<font size=2 face="sans-serif">mmchqos fs --enable ...  maintenance=1234iops
...<br></font><br><font size=2 face="sans-serif">Will apply the new settings to all currently
running and future maintenance commands.</font><br><br><font size=2 face="sans-serif">There is just a brief delay (I think
it is well under 30 seconds) for the new settings to be propagated and
become effective on each node.</font><br><br><font size=2 face="sans-serif">You can use `mmlsqos fs --seconds 70`
to observe performance.<br></font><br><font size=2 face="sans-serif">Better, install gnuplot and run samples/charts/qosplot.pl
or hack the script to push the data into your favorite plotter.</font><br><br><br><font size=2 face="sans-serif">--marc</font><br><br><br><br><font size=1 color=#5f5f5f face="sans-serif">From:      
 </font><font size=1 face="sans-serif">"Buterbaugh, Kevin
L" <Kevin.Buterbaugh@Vanderbilt.Edu></font><br><font size=1 color=#5f5f5f face="sans-serif">To:      
 </font><font size=1 face="sans-serif">gpfsug main discussion
list <gpfsug-discuss@spectrumscale.org></font><br><font size=1 color=#5f5f5f face="sans-serif">Date:      
 </font><font size=1 face="sans-serif">07/29/2016 11:57 AM</font><br><font size=1 color=#5f5f5f face="sans-serif">Subject:    
   </font><font size=1 face="sans-serif">[gpfsug-discuss]
mmchqos and already running maintenance commands</font><br><font size=1 color=#5f5f5f face="sans-serif">Sent by:    
   </font><font size=1 face="sans-serif">gpfsug-discuss-bounces@spectrumscale.org</font><br><hr noshade><br><br><br><font size=3>Hi All, </font><br><br><font size=3>Looking for a little clarification here … in the man
page for mmchqos I see:</font><br><br><font size=3>*  When you change allocations or mount the file
system, a brief</font><br><font size=3>   delay due to reconfiguration occurs before
QoS starts applying</font><br><font size=3>   allocations.</font><br><br><font size=3>If I’m already running a maintenance command and then
I run an mmchqos does that mean that the already running maitenance command
will adjust to the new settings or does this only apply to subsequently
executed maintenance commands?</font><br><br><font size=3>Thanks…</font><br><br><font size=3>—</font><br><font size=3>Kevin Buterbaugh - Senior System Administrator</font><br><font size=3>Vanderbilt University - Advanced Computing Center for
Research and Education</font><br><a href=mailto:Kevin.Buterbaugh@vanderbilt.edu><font size=3 color=blue><u>Kevin.Buterbaugh@vanderbilt.edu</u></font></a><font size=3>- (615)875-9633</font><br><br><br><tt><font size=2>_______________________________________________<br>gpfsug-discuss mailing list<br>gpfsug-discuss at spectrumscale.org<br></font></tt><a href="http://gpfsug.org/mailman/listinfo/gpfsug-discuss"><tt><font size=2>http://gpfsug.org/mailman/listinfo/gpfsug-discuss</font></tt></a><tt><font size=2><br></font></tt><br><BR>